The side panel wouldn’t fit because there was a Popsicle stick stuck up where it could not be seen. The panel had to be replaced anyway and that’s how the stick was found.
April 2014
April 25, 2014
Panel wouldn’t fit because of a Popsicle stick
Posted by badorder under 1977 Corvette Sting RayLeave a Comment
April 20, 2014
Replacing carpet and interior
Posted by badorder under 1977 Corvette Sting Ray | Tags: 1977 Corvette, interior clean up |Leave a Comment
The carpet and interior stripped for installation of new. As with most areas of this Vette work which had been done previously sucked. Seat belt apparatus had loose bolts or missing bolts. The subwoofer was mounted in a dangerous way which put stress on the window area of the body. If the owner of the vehicle had to hit the brakes hard, she would be wearing the 40 lb subwoofer and then be hit with the rear window in the back of the head since it was not sealed. Oh well, it will be installed properly now.
The bad condition of the rear compartment hatch. It’s cleaned up now.
New interior ready to be installed. Finished photos coming next post.
April 14, 2014
April 14, 2014
67′ Chevy may be a project soon
Posted by badorder under Boo Graphics and Body | Tags: 1967 Chevrolet pick up |Leave a Comment
The gentleman who made the impossible axle u-bolts to find for the 55′ trailer owns this 67′ which he may bring to me for the body work and paint
April 14, 2014
It was not worth it for me to buy the lumber and hardware, and to measure and cut, when I can buy the complete table ready to assemble for $60
April 14, 2014
1955 trailer ready to go home for the owner to finish the interior
Posted by badorder under Boo Graphics and Body1 Comment
April 14, 2014
Interesting effect of light on feather edging of paint
Posted by badorder under Boo Graphics and BodyLeave a Comment
This was a damaged area of the trailer where the area around it was feather edged. The way the light hits it, it looks raised and shows an outline of what looks like a polar bear laying on top